Installing The Fieldbus Junction Box - Pilz PMCprimo C2 Operating Manual

Installation
6.1.4

Installing the fieldbus junction box

To network a PMCprimo C2 via CANopen, PROFIBUS DP you need a fieldbus junction
box. This is available as an accessory. The fieldbus junction box is plugged into the servo
amplifier.
To install the fieldbus junction box, follow the instructions below:
}
Switch off the mains voltages and 24 V supply.
} Connect the 9-pin female D-Sub connector X6D to the male connector X6 on the servo
amplifier.
} Turn the screws into the thread on the housing.
Fig.: Installing the fieldbus junction box on a servo amplifier
Operating Manual PMCprimo C2
1004683-EN-02
INFORMATION
Pin assignment, wiring and assembly are described in the operating manual
for the fieldbus junction box.
| 30