Installing The Fieldbus Junction Box - Pilz PMCprimo MC Operating Manual

Installation
5.4

Installing the fieldbus junction box

To network a PMCprimo MC via CANopen, PROFIBUS DP you need a fieldbus junction
box. This is available as an accessory. The fieldbus junction box is plugged into the servo
amplifier.
To install the fieldbus junction box, follow the instructions below:
Switch off the mains voltages and 24 V supply.
}
Connect the 9-pin female D-Sub connector X6D to the male connector X6 on the servo
}
amplifier.
Turn the screws into the thread on the housing.
}
Fig.: Installing the fieldbus junction box on a servo amplifier
Operating Manual PMCprimo MC
1003813-EN-03
INFORMATION
Pin assignment, wiring and assembly are described in the operating manual
for the fieldbus junction box.
| 28