8. Remove the bearing carrier from the rear drive shaft
and trailing arm.
9. Rotate bearing by hand and check for smooth
rotation. Visually inspect bearing for moisture, dirt, or
corrosion. Replace bearing if moisture, dirt, corrosion,
or roughness is evident.
u
10. Remove the four clips
retainers to the trailing arm.
11. Remove the lower stabilizer bar linkage fastener
Discard the nut.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
that secure the brake line
i
.
STEERING / SUSPENSION
12. Support trailing arm with suitable jack stand or
support.
13. Remove the lower shock bolt
14. Remove the front trailing arm bolt
15. Remove trailing arm from vehicle. Visually inspect
trailing arm, bushings, o-rings and spherical bearing
for wear.
16. Replace trailing arm if physically damaged.
17. Reverse this procedure to reinstall rear trailing arm.
NOTE
Use new fastener nuts upon installation of the rear
trailing arm and bearing carrier.
o
. Discard the nut.
a
. Discard the nut.
8
8.29