Front Bearing Carrier Installation - Polaris RZR XP Service Manual

FRONT BEARING CARRIER INSTALLATION

1. Install drive shaft axle through the backside of the
bearing carrier.
2. Install the upper and lower ball joint ends into the
front bearing carrier.
3. Install new pinch bolts
specification.
TORQUE
Ball Joint Pinch Bolts:
42 ft-lbs (57 Nm)
4. Apply Anti-Seize to drive shaft axle splines.
5. Install front wheel hub assembly
and hand tighten the castle nut. Install washers with
domed side out.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
q
and nuts. Torque to
w e
, cone washer ,
6. Install new brake caliper mounting bolts and torque to
specification.
TORQUE
Front Caliper Mounting Bolts:
30 ft-lb (41 Nm)
CAUTION
New bolts have a pre-applied locking agent which is
destroyed upon removal. Always use new brake caliper
mounting bolts upon assembly.
7. Install the steering tie rod end
bearing carrier.
8. Torque the tie rod end fastener
TORQUE
Tie Rod End Fastener:
15 ft-lbs (20 Nm) + 90°
FINAL DRIVE
r
onto the front
7
t
to specification.
7.5