Stabilizer Bar Removal - Polaris RZR 570 2013 Service Manual

STABILIZER BAR REMOVAL

1. If stabilizer bar linkages are installed, remove the nut
and linkage bushings (see "Exploded View").
2. Remove the hood and front bumper (see Chapter 10
– BODY COMPONENT REMOVAL, page
3. Remove the four T30 Torx fasteners retaining the
front bumper support to the frame.
NOTE
Properly support the bumper support and wires that are
attached.
4. Remove the two upper radiator retaining bolts (A)
and remove the four bolts (B) retaining the lower
radiator mount bracket and remove the bracket from
the frame
5. Allow radiator to sag down to allow access to
recovery bottle retaining screws and filler neck
retaining screws.
9926813 R04 - 2013-2016 RZR 570 Service Manual
© Copyright Polaris Industries Inc.
6. Remove retaining screws from recovery bottle and
filler neck. Allow the recovery bottle and filler neck to
hang down to access the four bolts retaining the
upper radiator mount bracket.
).
7. Remove the four bolts retaining the upper radiator
mount bracket and remove the bracket from the
frame.
8. Lift up on the stabilizer bar and remove it from the
vehicle.
STEERING / SUSPENSION
8.19
8