Polaris RZR XP Service Manual page 497

o
1. Install middle ROPS onto vehicle. Loosely install
M10 x 1.5 x 65 screws (PN7519903)
1.5 Nyloc nuts (PN 7547268)
ROPS mounts.
IMPORTANT
Bolts must be installed from the inner side of the middle
ROPS as shown.
2. Slide the LH rear ROPS mount
as shown.
NOTICE
There is a RH or LH marking on each mount to indicate
which side it is used on.
u
3. Install O-ring approximately 3/4" (20 mm) from the
end of the LH ROPS.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
© Copyright Polaris Industries Inc.
4. Install LH ROPS
j
and M10 x
2!
through the middle
5. Align lower bolster mount on the outside of the rocker
w
onto the LH ROPS
r
onto vehicle. Loosely install M10
x 1.5 x 45 screws (PN 7519906)
k
Nyloc nuts (PN 7547746)
2#
point. Install LH bolster onto the middle mount.
Loosely install M10 x 1.25 x 55 screws (PN 7519956)
s
and M10 x 1.25 flanged Nyloc nuts (PN 7547333)
l
onto the bolster and middle mount point.
frame mounting hole as shown. install M8 x 1.25 x 20
4!
screw (PN 7518450) into the mount. Torque
fastener to specification.
TORQUE
Lower Bolster Mounting Fastener:
14 ft-lbs (19 Nm)
BODY / FRAME
a
and M10 x 1.5
into the front mount
11
11.33