Inner Plunging Joint / Boot Replacement - Polaris RZR XP Service Manual

FINAL DRIVE
11. While pulling out on the CV shaft, fully extend the CV
joint and slide a straight O-ring pick or a small slotted
screw driver between the small end of the boot and
the shaft. This will allow the air pressure to equalize in
the CV boot in the position that the joint will spend
most of its life. Before you remove your instrument,
be sure the small end of the boot is in its correct
location on the shaft.
12. Install and tighten the small clamp
using the appropriate clamp tool.
7.18
INNER PLUNGING JOINT / BOOT
REPLACEMENT
1. Use a side cutters to cut and discard the boot clamps
q
r
on the boot
2. Remove the large end of the boot from the plunging
joint and slide the boot down the shaft.
3. Remove the large circlip near the boot end of the
plunging joint.
4. Clean the grease from the face of the joint.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
.
© Copyright Polaris Industries Inc.