FINAL DRIVE
6. Inspect the roller surface on the inside of the ring gear
for gouging/rough spots.
7. Inspect the roll cage
excessive wear. If damaged, replace the roll cage
assembly.
a
8. Inspect the rollers
rollers must slide up, down, in and out freely within
the roll cage sliding surfaces and H-springs.
7.32
o
assembly for cracks or
for nicks and scratches. The
FRONT GEARCASE REMOVAL
1. Locate front propshaft roll pin and use roll pin removal
tool to remove. Discard roll pin.
2. From the left front wheel well, disconnect front
gearcase wiring harness
3. Remove both front wheels.
4. Remove left tie rod end nut
end joint with a proper pulling tool. Repeat the
procedure for the opposite side of the vehicle.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
q
.
w
, and remove tie rod
© Copyright Polaris Industries Inc.