Transmission / Gear Position Switch; Brake Pressure Switch - Polaris RZR XP Service Manual

ELECTRICAL

TRANSMISSION / GEAR POSITION SWITCH

TESTING
1. The transmission (gear position) switch
on the RH side of the transmission and can be
accessed through the rear RH wheel well area.
2. Disconnect the transmission switch harness by lifting
the connector lock and pulling on the connector. Do
not pull on the wiring.
3. Test the transmission switch continuity readings for
each gear position and compare to the specification
table below.
GEAR
WHEN MEASURED AT SWITCH
POSITION
HIGH
LOW
NEU
REV
PARK
12.16
q
is located
RESISTANCE VALUE
TERMINALS A AND B
620 Ω
300 Ω
160 Ω
75 Ω
24 Ω

BRAKE PRESSURE SWITCH

The brake pressure switch
line outlet on the master cylinder.
TORQUE
Brake Pressure Switch:
15 ft-lbs (20 Nm)
Always replace brake system seals if fastener is
loosened or removed.
1. Disconnect the wire harness from the brake switch.
2. Connect an ohmmeter across switch contacts.
Reading should be infinite (OL).
3. Apply foot brake and check for continuity between
switch contacts. If there is no continuity or greater
than 0.5 Ω resistance when the brake is applied with
slight pressure, first clean the switch contacts and re-
test. Replace switch if necessary.
9929419 R02 - 2018-2019 RZR XP / XP 4 Turbo S Service Manual
q
is located on the rear brake
NOTE
© Copyright Polaris Industries Inc.