Siemens SC 7000 Service Manual page 86

Service Manual
13.1.1 IBP Test setup
13.1.2 HEMO2/4 POD Channel A
Monitor Zero Function
70
300
290
280
270
260
250
240
230
220
210
200
190
180
170
160
150
140
130
120
110
100
90
80
70
60
5
40
20
0
Manometer
Pressure
Transducer
Tester
Figure 4-3 IBP Functional Verification Test Setup for HEMO2/4 PODs
If verifying proper IVP functioning of only the Monitor, do sections 13.1.1
and 13.1.2, and then go on to section 13.2. If functionally verifying the
HEMO POD also complete sections 13.1.3, 13.1.4, and 13.1.5.
1) With MultiMed cable and all other patient inputs unplugged from
monitor, power-cycle monitor. Select NO to clear display.
2) Plug cable from HEMO POD IBP SC 9000 output into Aux./Hemo3
input on SC 7000 or SC 9000XL monitor.
3) With MAIN screen displayed, connect BP output from simulator to first
input, channel A, on HEMO POD adapter.
4) Set IBP simulator for a static pressure = 0 mmHg.
Note: "Zero Required" message, identified by same pressure label is
shown in LCD window for channel A on front of HEMO POD appears
on display.
5) Press Zero All key on HEMO POD.
6) Verify that a "Zero Accepted" message that changes to "Static
Pressure", both identified by the same pressure label, appear in the
message field.
7) Select a pulsatile pressure on patient simulator.
8) Assure that Cal Factor and Manometer Cal are set to 100.
9) Verify that pressure reading on monitor is in agreement with values
generated by pressure signal from simulator.
10) If monitor is an SC 9000XL, plug cable from HEMO POD IBP SC 9000
output into Aux./Hemo2 input and repeat steps 3 through 9. Otherwise,
continue.
11) If functionally verifying only the SC 7000 or SC 9000XL, omit the
remaining steps in this section and go to
functionally verifying HEMO POD, go on to step 12.
Siemens Medical Systems, EM-PCS, Danvers
NOT A CONTROLLED DOCUMENT
SC 7000 and SC 9000XL Patient Monitors
Inflation
Bulb
Stopcock
(Closed)
Section
7k9kXLSM.c4.CD_ROM.fm/04-99/kaupp
13.2. If also
ASK-T898-03-7600