Siemens SC 7000 Service Manual page 158

Service Manual
4 Configuring Monitor
142
16. Central Station enabled: yes or no: If you choose yes, bedside monitor
expects an alarm acknowledgment from MVWS. If it doesn't get one, it
goes to its highest alarm volume and indicates an off-line condition.
• If you choose no, bedside monitor does not expect an acknowledg-
ment from MVWS and will not go to its highest alarm volume.
• If there is no M V
ULTI
this bed is NOT to be centrally monitored, choose "NO."
Table 4 Monitor Configuration Parameters
Network Mode Direct Net.
Bed
CPS/IDS
Care Unit
Monitoring Unit
Hospital
Recorder 1
Recorder 2
Recorder Use Network
1. On Main menu, access Monitor Setup → Unit Manager, and enter
Clinical password (375).
2. Select Menu Setup, and set Menu Time Limit to OFF.
3. On Main menu, access Monitor Setup → Biomed → Service, and enter
Biomed password (4712).
4. For each configuration parameter, enter data from Table 1 and select
"Accept".
Note: For numerical fields, rotary knob increments and
decrements numbers in the field as well as enters the data.
5. After all data has been entered, recheck data and then select Save
ALL.
Note: Monitor saves all entries, and then power-cycles if
Network Mode or any IP address parameters were changed.
Menu Time Limit automatically resets to ON if monitor
power-cycles.
6. Power-cycle monitor, unless monitor power-cycled in 5.
7. Connect monitor to network, and verify on MVWS that monitor
communicates with MVWS and configuration contains no duplicate
names.
8. This completes monitor setup.
Siemens Medical Systems, EM-PCS, Danvers
NOT A CONTROLLED DOCUMENT
SC 7000 and SC 9000XL Patient Monitors
W S on this I
IEW ORK TATION
Network Config
Host ID
Monitoring Unit ID
IP Address
Subnet Mask
Default Route
Remote Silence
Remote Control
Alarm Group
Central Station
Save ALL
7k9kXLSM.ape.CD_ROM.fm/04-99/kaupp
N , or
NFINITY ETWORK
z
y
191.1. y . z
255.255.0.0
0.0.0.0
ASK-T898-03-7600