Siemens SC 7000 Service Manual page 136

Service Manual
Table C-1Diagnostic Log Codes (Continued)
Code
xxx = any
alphanumeric
characters
8018fxxx
80190xxx
80196005 boot_erase_CPS_image failed to erase
FLASH with status: A
80196006 Chip timed out at: A wrote: B, read: C
8019601d Flash program write verify failed at A.
wrote: B, read: C
8019700c time=A
80199xxx PCMCIA Interface - related
8019axxx
801ac00b Pod Type A Conn B, S/N=C, event D
state E
801ac00c Pod Type A, Conn B, S/N=C, event D
state E
801adxxx
801aexxx
801b7000 ERROR: load_34010
120
Description
Siemens Medical Systems, EM-PCS, Danvers
NOT A CONTROLLED DOCUMENT
SC 7000 and SC 9000XL Patient Monitors
Cause
Try upgrading SW to
currently released version.
If error persists, replace
Main Processor Board
Subassembly.
CPS or IDS flash Check Docking Station
mem failure connection. Retry
download. replace CPS or
IDS if error persists.
Flash memory failed Re-download software. If
tests when doing a problem persists then
download. Bit one is replace Main Processor
always on. Board Subassembly if
downloading monitor, or
replace CPS or IDS if
downloading CPS/IDS.
Monitor flash failed Re-download software. If
tests when doing a problem persists, replace
download Main Processor Board
Subassembly.
Heart blip not Ignore
showing; most likely
due to rapid screen
re-draws
Retry download. If error
persists, return card.
Pod would not power Check/replace in this order
on or off. Connector pod/cartrige, cable, Main
number in description Processor Board
string are: 1,2,3- Subassembly.
hemo pod 4-reserved
5-etCO
2
Comm error, CRC IF problem persists, check
error connector or replace pod
Try upgrading SW to
currently released version.
If error persists, replace
Main Processor Board
Subassembly.
34010 Failure Replace Main Processor
Board Subassembly
Action
ASK-T898-03-7600
7k9kXLSM.apc.CD_ROM.fm/04-99/kaupp