Table of Contents
Advertisement
Version 1.0
5.
Repeat Steps 3 and 4 for the other mounting point.
6.
Repeat this procedure for the other stationary slide. Your rack should resemble
the following image:
To install the stationary rails on the rear of a tapped hole equipment rack:
1.
Locate the following components:
4 x 10-32 x 5/8" screws
•
2.
Expand and line up the unpainted side of the stationary rail on the outside of the
rear rack rail at the same height used for the front mount point.
3.
Place one 10-32 screw through the stationary rail ear and screw in place.
SYSTEM INSTALLATION
Acme Packet 4500 Hardware Installation Guide 41
Advertisement
Table of Contents
Need help?
Do you have a question about the Acme Packet 4500 and is the answer not in the manual?
Questions and answers