Basic Line Filter For I/R Modules - Siemens Simodrive 611 Configuration Manual

02.12
05.01
7.4.4

Basic line filter for I/R modules

Description
The basic line filter for I/R modules are designed for use in machines in which
the conducted interference in the frequency range is to be reduced in accor-
dance with EMC regulations.
The machine manufacturer must perform the EMC–compliant CE certification
for the product before it is implemented.
Note
The company that puts the machine on the market takes full responsibility for
ensuring CE EMC conformity and that the basic line filter is used correctly. The
machine manufacturer (OEM) must have the machine conformity confirmed
(e.g. by the EPCOS Company; mailto:emv.labor@epcos.com).
Basic Line Filters have properties similar to line filters that are generally
available. The Basic Line Filter offered by Siemens, however have the
advantage that they have been system–tested and released for
SIMODRIVE 611. If they are used, taking into account the secondary
conditions, then the Siemens system certificates for the converter system, such
as CE, UL, etc. remain valid and do not result in loss of warranty!
The Basic Line Filters can be used in accordance with the following general
conditions for ensuring CE conformity with regard to cable–borne interference:
S
S
S
Caution
The connections/terminals may not be interchanged:
S
S
If this is not observed, the line filter could be damaged.
© Siemens AG 2012 All Rights Reserved
SIMODRIVE 611 Configuration Manual (PJU) – 02/2012 Edition
The machine/system must only be used in industrial networks.
No. of axes <12.
Total cable lengths <150 m (motor cables, power supply cable between the
line filter and I/R module).
Incoming line supply cable to LINE/NETZ L1, L2, L3
Outgoing cable to the line reactor to LOAD/LAST L1', L2', L3'
7 Line Supply Connection
7.4 Line filters for I/R and UI modules
7
7-235