Removing And Installing Engine Speed Sender G28 - Volkswagen Golf 2004 Workshop Manual

– Apply silicone sealant bead as shown to the clean sealing sur‐
face of sealing flange.
– Install sealing flange immediately and tighten all bolts lightly.
Note
When fitting sealing flange with oil seal installed use guide sleeve
-T10053/1- .
– Tighten securing bolts for sealing flange to 15 Nm using alter‐
nate and diagonal sequence.
– Install crankshaft toothed belt pulley.
– Specified torque of new centre bolt
– Installing sump:
Golf, Golf Plus, Touran
Passat ⇒ page 117
– Install toothed belt ⇒ page 51
– Install poly V-belt ⇒ page 16
Note
Sealing compound must dry for approx. 30 minutes after instal‐
lation. Only then fill with engine oil.
2.4 Removing and installing engine speed
sender -G28-
Special tools and workshop equipment required
♦ Hexagon key extension, 4 mm -T10370-
– Remove insulation tray. ⇒ General body repairs, exterior;
Rep. gr. 50 ; Body - front; Assembly overview - noise insula‐
tion .
– Clamp off coolant hoses at oil cooler using hose clamp and
pull off hoses.
– Remove oil filter bracket.
Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
⇒ Item 19 (page 18)
⇒ page 89
.
.
.
2. Removing and installing sealing flange and flywheel
37