Volkswagen Golf 2004 Workshop Manual page 28

Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
– Tighten bolts for engine support in the sequence shown
1
-1...3- to 40 Nm + / 2 turn (180 °) further. To do this, raise or
lower engine using support bracket -10 - 222 A- .
I : Engine support with less clearance to engine
II: Engine support with greater clearance to engine
Note
Before installing assembly mounting, tighten all engine support
bolts to prescribed torque.
– Install assembly mounting between engine and body (renew
securing bolts) ⇒ page 14
– Bolt engine assembly mounting to engine support -arrows- by
bringing contact surfaces together using support bracket
-10-222A- . Specified torque: 60 Nm + 90° (1/4 turn) further
Further assembly is basically the reverse of the dismantling se‐
quence. In the process, note the following:
♦ Ensure that fuel hose connections are tight.
♦ Do not interchange supply and return lines (return line blue or
with blue markings, supply line black).
♦ When installing charge air pipes, ensure that locking lugs en‐
gage correctly.
– Install wheel housing liner.
– Install noise insulation tray. ⇒ General body repairs, exterior;
Rep. gr. 50 ; Body - front; Assembly overview - noise insula‐
tion .
22
Rep. gr.13 - Crankshaft group
.