– When the temperature is reached, take spur gear up using
pliers, as shown in illustration.
Note
Take care not to damage the splines on the spur gear.
– Slide spur gear quickly by hand without canting onto crank‐
shaft end until stop using fitting tool -10 - 203- .
– Allow the spur gear to cool down a few minutes and then install
balancer shaft module
3.9
Installing balancer shaft module
Installing a new balancer shaft module
Installing a previously used balancer shaft module again
⇒ page 115
3.9.1
Installing a new balancer shaft module
Special tools and workshop equipment required
♦ Locking device -T10255-
Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
⇒ page 111
.
⇒ page 111
3. Parts of lubrication system (Passat)
111