Volkswagen Golf 2004 Workshop Manual page 86

Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
– Remove bracket for exhaust gas recirculation cooler.
– Remove toothed belt from camshaft pulleys
– Remove camshaft pulley securing bolts -1- and -2-.
– Remove camshaft pulleys from hubs.
– Loosen hub securing bolt -1-.
– To do this, use counterhold -T10051- .
– Loosen hub securing bolt about 2 turns.
– Fit puller -T10052- and align it with holes in hub.
– Tighten securing bolts -1-.
– Apply tension to hub by evenly tightening puller -2- until hub
separates from taper of camshaft.
Note
When doing this, hold puller with 30 mm spanner.
– Remove hub from taper of camshaft.
– Remove exhaust camshaft hub in the same way.
– Remove cylinder head cover
– Remove tandem pump
Bolted connection for rocker arm shaft
– Loosen lock nut of adjustment screw -A- and back out screw
until respective rocker arm lies against plunger spring of unit
injector.
– Unscrew bolts -4, 1 and 5-, then remove bolts -2 and 3- evenly
and alternately.
– Remove rocker arm shaft.
– Unscrew upper securing bolts of rear toothed belt guard.
80
Rep. gr.15 - Cylinder head, valve gear
⇒ page 51
⇒ page 49 .
⇒ page 227 .
.