Volkswagen Golf 2004 Workshop Manual page 79

13 - Exhaust roller rocker fingers
❑ Do not interchange used roller rocker fingers (mark).
❑ With hydraulic valve clearance compensation.
❑ Check roller bearing.
❑ Removing and installing
14 - Seal
❑ Do not additionally oil or grease the oil seal sealing lip.
❑ Before installing, remove residual oil from camshaft journal using a clean cloth.
❑ To install, mask off groove on camshaft taper (e.g. using Sellotape).
❑ Removing and installing
15 - Cylinder head
❑ See note ⇒ page 47
16 - Inlet valves
❑ Valve dimensions
17 - Exhaust valves
❑ Valve dimensions
18 - O-ring
❑ Renew.
19 - Shaft
❑ For roller rocker fingers.
❑ Removing and installing
20 - 10 Nm
21 - Sealing plug
❑ Renew.
❑ 10 Nm
22 - Shaft
❑ For roller rocker fingers.
❑ Removing and installing
23 - Bearing shell
❑ Do not interchange used bearing shells (mark).
❑ Ensure that retaining lugs are correctly seated in bearing caps and cylinder head
24 - Exhaust camshaft
25 - Inlet camshaft
26 - Retaining frame
❑ Observe sequence when loosening and tightening
❑ Seal using silicone adhesive sealant -D 176501 A1- .
Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
⇒ page 75 .
⇒ page 84 .
.
⇒ page 76 .
⇒ page 76 .
⇒ page 75 .
⇒ page 75 .
⇒ page 79 .
73
2. Valve gear