Volkswagen Golf 2004 Workshop Manual page 13

– Insert engine bracket -T10012- in engine and gearbox jack -
V.A.G 1383/A- .
Note
Support pins must be secured to engine bracket -T10012- as
shown. The threaded support pin must be on the gearbox side.
– Fit engine bracket -T10012- to cylinder block with M10 x 25/
8.8 bolt and tighten to approx. 40 Nm.
– Lift engine and gearbox lightly using engine and gearbox jack
-V.A.G 1383/A- .
– Unbolt engine side of assembly mounting from engine support
from above -arrows-.
– Unbolt gearbox side of assembly mounting from gearbox
bracket from above -arrows-.
Note
To remove securing bolts, use stepladder VAS 5085.
♦
Engine with gearbox must be guided carefully when lowered
♦
to prevent damage to bodywork.
– Carefully lower engine with gearbox.
1.1.2 Procedures for Passat
– Read fault memories of all control units before removal ⇒ Di‐
agnosis tester VAS 5051; Guided fault finding; Vehicle system
test or VAS 5052; Vehicle self-diagnosis .
– With ignition switched off, disconnect earth strap from battery
⇒ Rep. gr. 27 .
– Remove engine cover.
To do this, pull engine cover upwards abruptly at front and right
-arrows A- and then pull forwards out of rear fastening
-arrow B-.
Golf 2004 ➤ , Golf Plus 2005 ➤ , Passat 2006 ➤ , Touran 2003 ➤
4-cylinder diesel engine (2.0 l engine, 4 valve) - Edition 02.2011
1. Removing and installing engine
7