Multi-Program Method; Number And Types Of Registerable Programs - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (1/2)
2 PLC Processing Program

2.6 Multi-Program Method

2.6 Multi-Program Method
Several sequence programs can be registered in the CNC and sequentially executed.
By using this function, the sequence program can be split into each process and developed.
The multi-program method is used by designating an execution type and execution order in the setting screen in GX
Developer/GX Works2 and sending the parameter files to the NC.
The execution type and the head of the process cannot be designated with reserved labels.

2.6.1 Number and Types of Registerable Programs

The maximum registrable number of the sequence program differs depending on the models as shown below.
 M800V Series : 120
 M80VW, M80V Type A/M80V Type B : 60
The above is the total number of the whole projects.
Only one execution type can be set to one program. There are 5 kinds of execution type as shown below.
"Initial" (Initialization process)
"Scan" (High-speed process)
"Scan" (Main process)
"Standby" (Standby process)
"Constant cycle"
IB-1501667-B
This starts up only once when the power is turned ON.
This starts up at the standard interrupt cycle.
This starts up constantly except during the high-speed process.
This is called from the high-speed process or main process.
This execution type is not used.
10