Relation With Other Functions - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
15 Multi-axis and Multi-part System
15.3 Single Block Between Part Systems
Cycle operation startup after stopping single block operation and cycle operation suspension
Start cycle start for all part systems after stopping single block operation or suspending cycle start while operating single block
between part systems. In order to maintain synchronization between part systems, the single block cannot progress until all
part systems are running in cycle start mode. The operation error (M01 1045) is generated. If you do not want to start a
particular part system, turn OFF (while in the cycle start suspended state) the cycle start suspension signal (*SP) for that part
system and start cycle start.
If you do not want to start part system 3
Part system 1
Automatic operation "start" (ST)
Automatic operation "pause" (*SP)
Part system 2
Automatic operation "start" (ST)
Automatic operation "pause" (*SP)
Part system 3
Automatic operation "start" (ST)
Automatic operation "pause" (*SP)

15.3.3 Relation with Other Functions

 The synchronization between part systems OFF is enabled with part systems for which single block between part systems
is disabled. Cycle operation is not suspended for other part systems even if the single block operation is stopped. Cycle
operation is not suspended when single block operation is stopped for other part systems.
 Sub part systems under sub part system control I/II are also subject to single block between part systems. Turn ON the
synchronization between part systems OFF to disable single block between part systems operation for sub part systems.
 During manual arbitrary reverse run, operation will continue in the single block between part systems enabled state even if
the single block between part systems enable signal is turned OFF.
899 IB-1501668-B