Mitsubishi Electric M800VW Series Programming Manual page 654

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.12 Chopping
[The operation of the compensation amount fixed method]
Compensation amount record area (R register: For N sets)
Error status
0 Override | Axis | Up dead pt. | Bottom dead pt. | No. of cycles | Compen. amnt (Width) | Compen. amnt (Ctr) | (Open to user)
Override | Axis | Up dead pt. | Bottom dead pt. | No. of cycles | Compen. amnt (Width) | Compen. amnt (Ctr) | (Open to user)
1
N - 2 Override | Axis | Up dead pt. | Bottom dead pt. | No. of cycles | Compen. amnt (Width) | Compen. amnt (Ctr) | (Open to user)
N - 1 Override | Axis | Up dead pt. | Bottom dead pt. | No. of cycles | Compen. amnt (Width) | Compen. amnt (Ctr) | (Open to user)
14 R registers are required per one set.
For N sets, the number of R registers required is 14*N+4.
Chopping start
Record mode?
Yes
Set the initial
compensation amount to
"0".
Perform chopping
operation using the initial
compensation amount.
Record the compensation
amount in the record area.
END
Completion status Command - Feedback
No (Playback mode)
Set the compensation data
in the record area as
the initial compensation
amount.
Perform chopping
operation using the initial
compensation amount.
633 IB-1501668-B