Multi-Project Setting Parameters (Project Setting) - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (1/2)
11 Parameters
11.3 Other Parameters

11.3.2 Multi-Project Setting Parameters (Project Setting)

The parameters that set the multi-project will be described in this section.
Follow these parameter settings and execute the each project in order.
Rebooting CNC is required after the parameter setting.
Default
Parameter name
(Initial state)
1
Maximum project No
100% to Project 1 0 to 100
Project ratio
ON for only Proj-
Execution project ect 1
Startup from Proj-
ect 1 in order
Execution order
Setting range
1 to 6 Specify the maximum project No.
The limit of the project No. that can be set will differ depending on the ma-
chine type.
(Refer to "2.2.2 Range of Usable Project") (*1)
For each project being used, specify the size ratio of the sequence program
storage area and the data storage area.
The total number of project to be used should be set to 100 or less.
The size will be set to be in increments of 4 bytes.
(If it is not the multiple of 4, the fractions will be rounded off.)
The setting cannot be carried out to the section other than the project being
used. (*2)
ON/OFF Specify the project to be executed.
The setting cannot be carried out to the section other than the project being
used. (*3)
1 to the number Specify the execution order of the project to be executed.
of the usable Specify this order within the setting range 1 to 6, regardless of the number of
projects project that can be used. (*4)
The projects start up in the ascending number which is assigned to the proj-
ects.
When the number of the order is assigned to the section other than execution
project, it will be ignored and not be executed.
The setting cannot be carried out to the section other than the project being
used.
463
Details
IB-1501667-B