Mitsubishi Electric M800VW Series Programming Manual page 626

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.10 Arbitrary Reverse Run
Valid G code
Only the specified G codes allow the reverse run. Valid G codes are shown below.
The G codes out of the list are invalid. Do not execute the reverse run to the invalid G codes.
G code group Valid/Invalid
00 Valid
01 Valid
02 Valid
03 Valid
04 Invalid
05 Invalid
06 Valid
07 Invalid
08 Invalid
09 Invalid
10 Invalid
11 Valid
12 Valid
13 Invalid
14 Valid
15 Invalid
16 Invalid
17 Invalid
18 Invalid
19 Valid
21 Invalid
(*1) The figure rotation cannot be executed with M98(G22).
(*2) In G95 modal, the reverse/forward run is executed with "the last commanded speed * spindle speed (mm/rev)"
 Insert G04; before the G code with "*".
 The G codes in "( )" are used for M2 format.
Valid G code (default G code if invalid)
G04, G52*, G53*, G60, G65, G92*, G92.1*, M96(ION), M97(I0F),
M98(G22) (*1), M99* (G23*)
GO0, G01, G02, G03
G17
G90, G91
G23(G23.1)
G94, G95 (*2) (According to the modal when the reverse run information is started to
be stored.)
G20, G21
G40
G49
G80
G98
G50, G51
G54, G55, G56, G57, G58, G59, G54.1
G64
G66, G66.1, G67
G40.1(G15)
G69(G69.1)
G97
G15
G50.1, G51.1, (G62)
G07.1 OFF, G13.1(G11)
605 IB-1501668-B