Mitsubishi Electric M800VW Series Programming Manual page 830

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.33 PLC Axis Control
Axis specification
PLC axis No. is designated.
(1st axis)
0: 1st axis
1: 2nd axis
2: 3rd axis
3: 4th axis
4: 5th axis
5: 6th axis
6: 7th axis
7: 8th axis
Only buffering mode allows the axis specification upon this data.
Single mode, which provides the PLC axis control valid signal for each axis, does not allow the axis specification upon this
data.
Operation mode
The operation mode for the PLC axis is designated.
For example, in the handle mode, R1n+5=6 (DATA) is set.
Operation mode
(1st axis)
(Numeric value data)
0: Rapid traverse (G0)
1: Cutting feed (G1)
2: Jog feed (+)
3: Jog feed (-)
4: Reference position return (+)
5: Reference position return (-)
6: Handle feed
The axis movement will not be affected by changing the operation mode, even while the axis is moving. The new operation
mode is validated at the next start.
Axis specification
809 IB-1501668-B