Connection Method - Mitsubishi Electric M800VW Series Programming Manual

M800V/M80V Series PLC Programming Manual (2/2)
13 Spindle Control

13.2 Connection Method

13.2 Connection Method
To serially connect the controller and spindle controller
Control unit
[Spindle forward run,
reverse run,
orientation command, etc.]
[Zero speed,
OPTH1,
spindle up-to-speed,
OPTH2
orientation completion signal, etc.]
To analog connect the controller and spindle controller
Remote I/O unit
Control unit
RIO1
CN1A
High-speed serial connection
DX***
[Zero speed, spindle up-to-speed,
orientation completion signal, etc.]
[Spindle forward run, reverse run,
orientation command, etc.]
Analog output
Axis drive unit
CN1B
Relay box
491
Spindle drive unit
Inverter, etc.
IB-1501668-B