Mitsubishi Electric M800VW Series Programming Manual page 599

M800V/M80V Series PLC Programming Manual (2/2)
14 PLC Help Function
14.2 Manual Speed Command
[Related signals]
(1) Manual speed command sign reversed (YC9E)
(2) Manual speed command reverse run valid (YC9F)
(3) In automatic operation "pause" (SPL: XC14)
(4) In manual speed command valid (XC48)
Contact Signal name
MANUAL SPEED COMMAND SIGN RE-
A
VERSED
[Function]
When the manual speed is commanded, this signal reverses the direction that has been commanded with the handle feed
or JOG feed.
[Operation]
When this signal is ON, a speed command in the (+) direction reverses the movement against the program. (Note that this
operation is not available unless the reverse run is valid.) A command in the (-) direction makes the movement as
commanded in the program.
Manual speed command Manual speed command
Reverse run valid
OFF (Invalid)
ON OFF
ON ON
In the modals that do not allow the reverse run
(thread cutting and synchronous tapping)
[Caution]
This signal is not valid when the "Manual speed command Reverse run valid" signal is OFF.
[Related signals]
(1) Manual speed command valid (YC9D)
(2) Manual speed command reverse run valid (YC9F)
IB-1501668-B
Signal abbre-
viation
Sign reversed
by (+) operation
Plus (+)
Plus (+)
Minus (-)
Plus (+)
$1 $2 $3
YC9E YDDE YF1E Y105E
Movement direction
by (-) operation
Plus (+)
Minus (-)
Plus (+)
The operation is ignored
578
$4