Table of Contents
Advertisement
14. Connect the redundant system fan cables.
15. Install the system air baffle on page 31.
16. Install the PCI air baffle on page 30.
17. Install the front bezel on page 28.
18. Install the access panel on page 26.
19. Do one of the following:
•
Server in rack mode: Install the server into the rack on page 53.
•
Server in tower mode: Return the server to an upright position.
20. Connect all peripheral cables to the server.
21. Connect each power cord to the server.
22. Connect each power cord to the power source.
23. Power up the server on page 23.
The installation is complete.
Memory options
IMPORTANT: This server does not support mixing LRDIMMs and RDIMMs. Attempting to mix any
combination of these DIMMs can cause the server to halt during BIOS initialization. All memory installed
in the server must be of the same type.
DIMM population information
For specific DIMM population information, see the DIMM population guidelines on the Hewlett Packard
Enterprise website (http://www.hpe.com/docs/memory-population-rules).
DIMM-processor compatibility
The installed processor determines the type of DIMM that is supported in the server:
84
Hardware options installation
Advertisement
Table of Contents
