Table of Contents
Advertisement
a. Place the access panel on the chassis, and slide it towards the front of the server.
b. Tighten the thumbscrews.
2. If a Kensington security cable was removed, connect it to the rear panel. See the security cable
documentation for instructions.
3. Do one of the following:
•
Server in rack mode: Install the server into the rack on page 53.
•
Server in tower mode: Return the server to an upright position.
4. Connect all peripheral cables to the server.
5. Connect each power cord to the server.
6. Connect each power cord to the power source.
7. Power up the server on page 23.
Remove the front bezel
Procedure
1. If the bezel is locked, power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. If the front bezel is locked by the internal locker, remove the access panel.
4. Open and remove the front bezel:
Operations
27
Advertisement
Table of Contents
