Maintenance And Replacement Of Components; What To Do After Scrapping - INVT Goodrive100 Series Instruction Manual

Goodrive100 inverters
Note:

Do not switch on or off the input power supply of the inverter frequently.

For inverters that have been stored for a long time, check and fix the capacitance and try to run it
again before utilization (see Maintenance and Hardware Fault Diagnose).

Cover the front board before running, otherwise electric shock may occur.

1.3.3 Maintenance and replacement of components




Note:

Please select proper torque to tighten screws.

Keep the inverter, parts and components away from combustible materials during maintenance and
component replacement.

Do not carry out any isolation and pressure test on the inverter and do not measure the control
circuit of the inverter by megameter.

1.3.4 What to do after scrapping


device should be provided.
Only qualified electricians are allowed to perform the maintenance, inspection, and
components replacement of the inverter.
Disconnect all power supplies to the inverter before the terminal wiring. Wait for at
least the time designated on the inverter after disconnection.
Take measures to avoid screws, cables and other conductive matters to fall into
the inverter during maintenance and component replacement.
There are heavy metals in the inverter. Deal with it as industrial effluent.
IKR Aandrijven en Besturen
www.ikr-industries.nl
Safety precautions