Status Request; Utc Time - Viavi ATC-5000NG Operation Manual

5.5.3

STATUS REQUEST

Command Syntax:
Description:
Example:
Return Value:
5.5.4

UTC TIME

Command Syntax:
Description:
Example:
Default:
Query:
Return:
Rev. L0
February 2020
{:ATC |:ATC5000NG}{:RCV |:RCVR}{:ST |:STATUS}?CR
This command returns a byte with the status of all eight receivers within the ATC-5000NG
(receivers in this context means any of the 8 defined functional "receivers" below - not physical
RF Hardware receivers). A "1" for the receiver associated bit means that the receiver is receiving
messages.
:ATC:RCV:ST?\r
FF (hexadecimal ASCII Byte)
Bit
0x01
0x02
0x04
0x08
0x10
0x20
0x40
0x80
{:ATC |:ATC5000NG}{:RCV |:RCVR}{:UTC }SP{ON[,{PC|GPS|429}] | OFF}CR
This command enables or disables the UTC time format for the received messages timestamp.
When the UTC time is enabled, the UTC source definition is optional. By default, the UTC source
is from the PC time. The GPS source is hardware dependent.
:ATC:RCV:UTC ON,PC\r
Off
:ATC:RCV:UTC?\r
ON,PC
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Receiver
UUT DF Messages
UUT ATCRBS Replies
UUT UF Messages
UUT ATCRBS Interrogations
ATC-5000NG DF Messages
ATC-5000NG ATCRBS Replies
ATC-5000NG UF Messages
ATC-5000NG ATCRBS Interrogations
Operation, Remote Operation
Receiver Commands
1-2-5
Page 17