Viavi ATC-5000NG Operation Manual page 43

S T E P P R OC E DU R E
4
Plug an Ethernet Cable into the LAN Connector on the Front or Rear Panel of the ATC-5000NG. To
determine the proper Ethernet Address see Section 3.8.2 Network Connections Menu in this
manual. Enter the Ethernet Address and press the Connect button.
NOTE
THE AC POWER CABLE IS USED TO FULLY DISCONNECT THE TEST SET FROM AC
POWER. THE TEST SET SHOULD NOT BE POSITIONED SO THE DISCONNECTION OF
THE AC POWER CABLE IS PREVENTED.THE AC POWER CABLE IS USED TO FULLY
DISCONNECT THE TEST SET FROM AC POWER. THE TEST SET SHOULD NOT BE
POSITIONED SO THE DISCONNECTION OF THE AC POWER CABLE IS PREVENTED.
REMARQUE
LE CÂBLE D'ALIMENTATION C.A. SERT À COUPER COMPLÈTEMENT L'ALIMENTATION
C.A. DU DISPOSITIF DE TEST. LE DISPOSITIF DE TEST NE DOIT PAS ÊTRE PLACÉ
D'UNE MANIÈRE QUI EMPÊCHE LE DÉBRANCHEMENT DU CÂBLE D'ALIMENTATION C.A.
5 With the VNC Authentication screen displayed enter the ???, the password (atc) and select the OK
Button.
NOTE
THE ATC-5000NG PASSWORD (ATC) IS SET BY DEFAULT AT THE FACTORY. IF THE
OPERATOR HAS CHANGED THE PASSWORD OF THE ATC-5000NG, THE NEW
PASSWORD SHOULD BE USED.
1-2-3
Page 6
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Operation, Menus and Screens
Remote (VNC) Connection
(C O N T )
Rev. L0
February 2020