Viavi ATC-5000NG Operation Manual page 217

5.7.2.9.2 IDENTIFICATION MESSAGE SCHEDULE
Identification squitter is transmitted by the ATC-5000NG at a rate of 5.0 seconds.
Dynamic intruders (targets) allow definition of multiple time intervals where the Identification squitter can
be enabled or disabled.
Static intruders (targets) allow the user to enable or disable the Identification squitter for the entire
scenario.
5.7.2.9.2.A DYNAMIC IDENTIFICATION SCHEDULE
5.7.2.9.2.A.1
Command Syntax:
Description:
Default:
Example:
5.7.2.9.2.A.2
Command Syntax:
Description:
Numeric:
Example:
5.7.2.9.2.A.3
Command Syntax:
Description:
Numeric:
Example:
5.7.2.9.2.A.4
Command Syntax:
Description:
Numeric:
Example:
1-2-5
Page 54
INTERVAL ENABLE
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SIDENT}{:INT:
|:INTERVAL:}<interval number>{:ENA |:ENABLE}SP{ON | OFF}CR
This command enables or disables the identification squitter message of the specified intruder.
On
:ATC:SCE:DYN:2:SIDENT:INT:2:ENA ON\r
INTERVAL QUANTITY
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SIDENT}{:NINT
|:NINTERVALS}SP<numeric>CR
This command sets the number of identification squitter message intervals for the selected
intruder. The spaces not defined between intervals are considered off; therefore,
can define the intervals where the message
0 to 255 (decimal ASCII)
:ATC:SCE:DYN:1:SIDENT:NINT 3\r
INTERVAL START TIME
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SIDENT}{:INT:
|:INTERVAL:}<interval number>{:BEGIN}SP<numeric>CR
This command sets the start time for the selected identification squitter message interval for the
selected intruder. The spaces not defined between intervals are considered off; therefore,
can define the intervals where the message
the user
0 to 6550 seconds (decimal ASCII). Resolution is 0.1 seconds.
:ATC:SCE:DYN:1:SIDENT:INT:2:BEGIN 45\r
INTERVAL STOP TIME
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SIDENT}{:INT:
|:INTERVAL:}<interval number>{:END}SP<numeric>CR
This command sets the stop time for the selected identification squitter message interval for the
selected intruder. The spaces not defined between intervals are considered off; therefore,
can define the intervals where the message
the user
0 to 6550 seconds (decimal ASCII). Resolution is 0.1 seconds.
:ATC:SCE:DYN:1:SIDENT:INT:2:END 120\r
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Operation, Remote Operation
Scenario Commands
only
transmitted
is .
transmitted
is
transmitted
is
the user
only
.
only
.
Rev. L0
February 2020