Viavi ATC-5000NG Operation Manual page 353

1.2
REPACKING PROCEDURE
Perform the following steps to repack the equipment for shipment
• Make sure the bottom packing mold is seated on the floor of the shipping container.
•
Carefully wrap the Test Set with polyethylene sheeting.
• Place the Test Set into the shipping container, making sure the Test Set is securely seated in the
bottom packing mold.
•
Place the top packing mold over the top of the Test Set and press down until the top packing mold
rests solidly on the Test Set.
• Close the shipping container lids and seal with shipping tape or an industrial stapler. Tie all sides of
the shipping container with break resistant rope, twine or equivalent.
Figure 1.4.1 - 1 Repacking Procedure
1-4-1
Page 2
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Shipping, Shipping Test Sets
(Figure 1.4.1 - 1 below):
Repacking Procedure
Rev. L0
February 2020