Status Indicators - Viavi OneExpert DSL User Manual

Status indicators

The controls and indicators on the front panel are used to operate the OneExpert DSL, set
up tests, and view data detailed below.
Sync – Reports the status of G.fast/xDSL modem synchronization.
y
y
Network – Indicates the status of network connectivity.
y
y
y
y
NOTE:
The Sync and Network indicators alternately blink green when
in sleep mode (power saving mode).
Error – Solid red indicates error and alarm conditions.
Batt – A multi-color indicator that shows the battery status.
y
y
y
May 2020
Blinking green indicates that the modems are training.
Solid green indicates that the modems are synchronized (reached
Showtime).
Blinking green indicates that the unit is acquiring an IP address.
Solid green indicates frames an IP address has been acquired.
Blinking amber indicates a timeout; the unit was unable to acquire an IP
address.
If the Frame indicator is not illuminated, the network is not active (either
the unit is not connected or it is logged off.
Solid green indicates either the battery charge is higher than 30%, or that
an external source is powering the unit.
Solid amber indicates the battery is getting low, the charge is between
10% and 30%.
Solid red indicates the battery charge is critically low, less than 10%. An
audible beep occurs 30 seconds before shutdown.
OneExpert DSL User's Guide
22052280, Rev. 016
Chapter 2 Quick Tour
33