Viavi ATC-5000NG Operation Manual page 288

5.9.17.4.6 PULSE REPETITION FREQUENCY (PRF)
Command Syntax:
Description:
Numeric:
Default:
Example:
Query:
Return:
5.9.17.4.7 PULSE WIDTH
Command Syntax:
Description:
Numeric:
Default:
Example:
Query:
Return:
5.9.17.4.8 PRF SYNCHRONIZATION
Command Syntax:
Description:
Default:
Example:
Query:
Return:
5.9.17.4.9 SIDE LOBE SUPPRESSION (SLS)
Command Syntax:
Description:
Default:
Example
Example:
Query:
Return:
Rev. L0
February 2020
{:ATC |:ATC5000NG}{:XPDR}{:PRF }SP<numeric>CR
This command sets the pulse repetition rate (PRF).
1 to 10000 (decimal ASCII)
100
:ATC:XPDR:PRF 150\r
:ATC:XPDR:PRF?\r
150
{:ATC |:ATC5000NG}{:XPDR}{:PWIDTH |:PW }SP<numeric>CR
This command sets the pulse width. This command is valid only for the transponder interrogation
mode Pulse.
0 to 10 µs (decimal ASCII)
0
:ATC:XPDR:PW 1\r
:ATC:XPDR:PW?\r
1. 0
{:ATC |:ATC5000NG}{:XPDR}{:PRFSYNC}SP{ON |OFF}CR
This command turns on or off the synchronization output. This command is valid only for the
following transponder interrogation modes: P1 to P2, Pulse, DME 12 µs Spacing and DME 30 µs
Spacing. This synchronizes all of the PRF generator outputs to align with the master generator.
Off
:ATC:XPDR:PRFSYNC ON\r
:ATC:XPDR:PRFSYNC?\r
ON
{:ATC |:ATC5000NG}{:XPDR}{:SLS}SP{ON |OFF}[,{ON|OFF}]CR
This command turns on or off SLS (P2) pulse in an ATCRBS interrogation. The optional
{ON|OFF} is ignored if the interrogation mode is not "Alternate Mode A/Mode C." For "Alternate
Mode A/Mode C", the first {ON|OFF} is used to define the Mode A pulse and the second (or the
optional) is used to define the Mode C pulse.
Off
:ATC:XPDR:SLS ON\r
:ATC:XPDR:SLS ON,ON\r
:ATC:XPDR:SLS?\r
ON
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
(for Alternate Mode A/Mode C)
(or ON,ON for Alternate Mode A/Mode C)
Operation, Remote Operation
Transponder Commands
1-2-5
Page 125