Pulse Request - Viavi ATC-5000NG Operation Manual

5.3.5

PULSE REQUEST

5.3.5.1 FREQUENCY REQUEST
Command Syntax:
Description:
Example:
Return:
5.3.5.2 PULSE FALLTIME REQUEST
Command Syntax:
Description:
Example:
Return:
5.3.5.3 PULSE RISETIME REQUEST
Command Syntax:
Description:
Example:
Return:
5.3.5.4 PULSE POSITION REQUEST
Command Syntax:
Description:
Example:
Return:
5.3.5.5 PULSE POWER REQUEST
Command Syntax:
Description:
Example:
Return:
Rev. L0
February 2020
{:ATC |:ATC5000NG}{:MEA |:MEASURE}{:FREQ? |:FREQUENCY?} CR
This command returns the frequency of the incoming signal.
:ATC:MEA:FREQ?\r
Value is in ASCII data format specified in MHz. In case of the Float data format, the Value is
returned with three decimal points.
If no measurement Value is available, the Unit replies with not ready "#".
{:ATC |:ATC5000NG}{:MEA |:MEASURE}{:PUL |:PULSE}{:FALL?} CR
This command returns the fall time of the selected pulse.
:ATC:MEA:PUL:FALL?\r
Value is in ASCII data format specified in ns. In case of the Float data format, the Value is
returned without fractional part.
If no measurement Value is available, the Unit replies with not ready "#".
{:ATC |:ATC5000NG}{:MEA |:MEASURE}{:PUL |:PULSE}{:RISE?} CR
This command returns the rise time of the selected pulse.
:ATC:MEA:PUL:RISE?\r
Value is in ASCII data format specified in ns. In case of the Float data format, the Value is
returned without fractional part.
If no measurement Value is available, the Unit replies with not ready "#".
{:ATC |:ATC5000NG}{:MEA |:MEASURE}{:PUL |:PULSE}{:POS?|:POSITION?} CR
This command returns the position of the selected pulse.
:ATC:MEA:PUL:POS?\r
Value is in ASCII data format specified in ns. In case of the Float data format, the Value is
returned without fractional part.
If no measurement Value is available, the Unit replies with not ready "#".
{:ATC |:ATC5000NG}{:MEA |:MEASURE}{:PUL |:PULSE}{:POWER?} CR
This command returns the power of the selected pulse.
:ATC:MEA:PUL:POWER?\r
Value is in ASCII data format specified in dBm. In case of the Float data format, the Value is
returned with two decimal points.
If no measurement Value is available, the Unit replies with not ready "#".
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Operation, Remote Operation
Measurement Commands
1-2-5
Page 9