Hand Strap Rings; Status Indicators - Viavi AVX-10K Operation Manual

The RF I/O Connector is a combined (Duplex) connector that provides an RF output connection
and an RF Receiver input connection.
• ANT Connector
The ANT Connector is selectable as the instrument's antenna input connector.
The ANT connector should be selected to perform over the air testing using an external antenna
or when test parameters require maximum input sensitivity. This connector should be used
when measuring low level RF signals.
2.2.3.

Hand Strap Rings

Four rings are located at the corners of the device and can be used to attach the carry strap.
2.2.4.

Status Indicators

• TX: Transmit Indicator LED blinks green when transmitting to the device under test.
RX: Receive Indicator LED blinks green when the AVX-10K is receiving input from the device
•
under test.
• Error: This LED is solid red indicates error and alarm conditions. The type of error varies
depending on the application. Errors are displayed in the Utility Tray.
Batt: multi-color LED that indicates the battery status.
•
o Solid green indicates that either the battery charge is higher than 30%, or that an
external source is powering the unit.
o Solid amber indicates that the battery charge is getting low (charge is between 10% and
30%).
o Flashing red indicates the device is being powered by external AC Power and the battery
is not installed in the device.
o Solid red indicates that the battery charge is critically low, less than 10%. An audible
beep occurs 30 seconds before shutdown.
• Charge Status LED: located on the bottom, next to the DC Input connector. The Charge Status
LED is a multi-colored LED that indicates the charge status of the Battery.
Rev. 002
22135254 VIAVI
AVX-10K Operation
2022-08-25
Page 18 of 139