Viavi ATC-5000NG Operation Manual page 219

5.7.2.12.1.A.2
Command Syntax:
Description:
Numeric:
Example:
5.7.2.12.1.A.3
Command Syntax:
Description:
Numeric:
Example:
5.7.2.12.1.A.4
Command Syntax:
Description:
Numeric:
Example:
5.7.2.12.1.B STATIC DF=11 SCHEDULE - INTERVAL ENABLE
Command Syntax:
Description:
Default:
Example:
5.7.2.13 MODE S DATA PARAMETERS
5.7.2.13.1 CROSSLINK CAPABILITY (CC)
Command Syntax:
Description:
Default:
Example:
1-2-5
Page 56
INTERVAL QUANTITY
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SDF11}{:NINT
|:NINTERVALS}SP<numeric>CR
This command sets the number of DF11 squitter message intervals for the selected intruder. The
spaces not defined between intervals are considered off; therefore
the intervals where the message
0 to 255 (decimal ASCII)
:ATC:SCE:DYN:2:SDF11:NINT 3\r
INTERVAL START TIME
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SDF11}{:INT:
|:INTERVAL:}<interval number>{:BEGIN}SP<numeric>CR
This command sets the start time for the selected DF11 squitter message interval for the selected
intruder. The spaces not defined between intervals are considered off; therefore
define the intervals where the message
can
0 to 6550 seconds (decimal ASCII). Resolution is 0.1 seconds.
:ATC:SCE:DYN:2:SDF11:INT:2:BEGIN 55\r
INTERVAL STOP TIME
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:DYN: |:DYNAMIC:}<intruder no>{:SDF11}{:INT:
|:INTERVAL:}<interval number>{:END}SP<numeric>CR
This command sets the stop time for the selected DF11 squitter message interval for the selected
intruder. The spaces not defined between intervals are considered off; therefore
define the intervals where the message
can
0 to 6550 seconds (decimal ASCII). Resolution is 0.1 seconds.
:ATC:SCE:DYN:2:SDF11:INT:2:END 125\r
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:STAT: |:STATIC:}<intruder no>{:SDF11}{:ENA
|:ENABLE}SP{ON | OFF}CR
This command enables or disables the DF11 squitter message of the specified intruder.
On
:ATC:SCE:STAT:2:SDF11:ENA ON\r
{:ATC |:ATC5000NG}{:SCE |:SCENARIO}{:STAT: |:STATIC: |:DYN: |:DYNAMIC:}<intruder
no>{:CC}SP{ON | OFF}CR
This command either enables or disables crosslink capability bit for the specified intruder.
Off
:ATC:SCE:STAT:1:CC ON\r
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
only
transmitted
is .
transmitted
is
transmitted
is
Operation, Remote Operation
Scenario Commands
define
the user can
only
the user
.
only
the user
.
Rev. L0
February 2020