Error Led; Battery Led; Charge Status Led - Viavi CX100 ComXpert Operation Manual

1.6.3 Error LED

The Error LED indicates error and alarm conditions. Solid red indicates error and alarm
conditions. The type of errors varies depending on the application. Errors are displayed in
the Utility Tray.

1.6.4 Battery LED

The Battery LED is a multi-colored LED that indicates battery status.
•
Solid green indicates the battery charge is higher than 30% or that an external source
is powering the unit.
• Solid amber indicates the battery charge is getting low; the charge is between 10%
and 30%.
• Solid red indicates the battery charge is critically low, less than 10%. An audible beep
occurs 30 seconds before shutdown.

1.6.5 Charge Status LED

The Charge Status LED is located on the bottom of the device next to the DC Input
connector. The Charge Status LED is a multi-colored LED that indicates the charge status
of the device.
•
Solid green indicates charging is complete and the battery is fully charged.
• Solid amber indicates the battery is charging.
• Slow flashing red indicates the battery charge is critically low, less than 10%.
•
Fast flashing red indicates charging was suspended due to a fault and user
intervention is necessary (for example, the wrong charger is attached).
• Solid red indicates charging was suspended due to overheating; no user intervention
is necessary. The unit can continue to run; charging resumes when the device
temperature drops to within acceptable parameters.
22144015
August 2023
See section 3.1.22, "Notifications", on page 3-13
Figure 1-7 CX100 Battery LED
CX100 ComXpert Operation Manual
Chapter 1 Overview of the CX100
LED Indicators
for information.
Rev 002
1 - 13