Viavi ATC-5000NG Operation Manual page 31

1.2.2
GROUNDING POWER CORD
WARNING
DO NOT USE A THREE-PRONG TO TWO-PRONG ADAPTER PLUG. DOING SO
CREATES A SHOCK HAZARD BETWEEN THE CHASSIS AND ELECTRICAL
GROUND.
Avertissement
N? U TILISEZ PAS D? A DAPTATEUR DE TROIS BROCHES À DEUX BROCHES. UN
TEL ADAPTATEUR CRÉE UN DANGER DE CHOC ENTRE LE CHÂSSIS ET LA
MASSE.
For AC operation, the AC Line Cable is equipped with standard three-prong plug and must be connected
to a properly grounded three-prong receptacle that is easily accessible. It is the customer's responsibility
to:
•
Have a qualified electrician check receptacle(s) for proper grounding.
• Replace any standard two-prong receptacle(s) with properly grounded three-prong receptacle(s).
1.2.3
VENTILATION
The ATC-5000NG is air-cooled by fans that draw air through vents in the case. Do not obstruct the air
vents while the instrument is in use. Avoid standing the instrument on or close to other equipment that is
hot.
1.2.4
OPERATING SAFETY
WARNING
DUE TO POTENTIAL FOR ELECTRICAL SHOCK WITHIN THE TEST SET, THE
CASE ASSEMBLY MUST BE CLOSED WHEN THE TEST SET IS CONNECTED TO
AN EXTERNAL POWER SOURCE.
Avertissement
EN RAISON DU RISQUE DE CHOC ÉLECTRIQUE DANS LE DISPOSITIF DE TEST,
SON BOÎTIER DOIT ÊTRE FERMÉ LORSQUE LE DISPOSITIF EST CONNECTÉ À
UNE SOURCE D'ALIMENTATION EXTERNE.
1.2.5
CAUTION AND WARNING LABELS
Extreme care should be exercised when performing any operations preceded by a CAUTION or
WARNING label. CAUTION labels appear where possibility of damage to equipment exists and
WARNING labels denote conditions where bodily injury or death may result.
1.3
AC POWER REQUIREMENTS
The ATC-5000NG power supply operates over a voltage range of 100 to 240 VAC, 50 to 60 Hz.
1-2-1
Page 2
ATC-5000NG ATC/DME Test Set Operation Manual
Subject to Export Control. See Cover Page for details.
Operation, Installation
AC Power Requirements
Rev. L0
February 2020