Id Tries; Antenna Tries; Read Tries; Write Tries - Intermec IF30 User Manual

Chapter 3 — Creating and Using RFID Applications
46
To enable Timeout Configuration Mode
1 Check the check box and then click Save Changes. The
screen refreshes. The Antenna Tries setting is replaced by
Antenna Timeout, and the ID Tries setting is replaced by the
ID Timeout.
2 Specify the value (in ms) for the timeout in the entry fields
and then click Save Changes.

ID Tries

Sets the maximum number of times the reader executes the
identify algorithm before a response is returned to a Read or
Write command.
In practice, this is the number of times a tag ID attempt is made
for each antenna being used. Valid range is 1 to 254. Default is 3.
This setting is equivalent to the IDTRIES BRI attribute.

Antenna Tries

Sets the maximum number of ID Tries that the reader executes
per antenna. Valid range is 1 (default) to 254.
This setting is equivalent to the ANTTRIES BRI attribute.

Read Tries

Sets the maximum number of times the read algorithm is
executed before a response is returned to a Read command.
In practice, this is the number of times an identified tag will be
read until the read is successful. Valid range is 1 (default) to 254.
This setting is equivalent to the RDTRIES BRI attribute.

Write Tries

Sets the maximum number of times the write algorithm is
executed before a response is returned to a Write command.
In practice, this is the number of times an identified tag will be
written until the write is successful. Valid range is 1 to 254. The
default is 3.
This setting is equivalent to the WRTRIES BRI attribute.

Initialization Tries

Sets the maximum number of times the reader attempts to
initialize a tag. Valid range is 1 (default) to 254.
This setting is equivalent to the INITTRIES BRI attribute.
IF30 Fixed Reader User's Manual