Chapter 2 — Configuring Network Settings
Configuration Settings For Your Network
Configuring Ethernet Settings
24
This chapter assumes that you are using the IF30 web browser
interface to configure network settings on the IF30. For help,
"Using the Web Browser Interface" on page 14.
You can also configure network settings by:
• using a communications program to access the IF30. For
help, see "Using a Communications Program" on page 10.
• using Intermec Settings from within the Intermec
SmartSystems Console. For help, see "Using Intermec
SmartSystems Foundation" on page 54.
This section explains how to configure the wired Ethernet
settings using the web browser interface:
• DHCP mode
• (If DHCP is enabled) DHCP server name, user class, and
vendor class
• IP address
• IP subnet mask
• IP router (gateway)
• Link speed
Note: If you are using a DHCP server, you may not need to
configure Ethernet settings. For more information, contact your
network administrator.
For help with enabling IPv6 and configuring settings, see
"Enabling IPv6" on page 27.
IF30 Fixed Reader User's Manual