EasyDrive CV3100 Series Instruction Manual page 96

CV3100 series and MINI series high performance general purpose inverter instruction manual
frequency setting channel are specified by status of the three terminals. Please refer to
Table 6-1 for their corresponding relation.
9：Forward jog control
Operation of forward jog controlled by external terminals.
10: Reverse jog control
Operation of forward jog controlled by external terminals.
Forward jog gives priority to reverse jog. When they are closed at the same time,
forward jog is in effect.
11：Inverter running forbidden command
If this terminal function is available, the running frequency will stop freely and
standby of inverter is forbidden to start. It main apply for security interaction occasion
12：Freq. increasing command
Used for controlling frequency increasing.
13：Freq. decreasing command
Used for controlling frequency decreasing.
14：Peripheral failure input（constant open and effectual when closed）
Can by input the peripheral failure signal to enable inverter to perform fault
monitoring against the exterior equipment.
15：Three-line operation control
When P0.04=1 and combination of running command terminals is three-line control,
the terminals defined will become to stop trigger switch of the inverter. Detail is
referred to parameter P4.06 explanation.
16：DC braking command
When inverter stop, if the terminals close defined by this parameter, DC braking
function start up at the time output frequency is lower than start frequency of DC
brake ,until the terminals brake up. Please refer to parameters P2.12-P2.14 for details.
17：Counter reset signal input
Working with the 18 item function to reset the counter built in the inverter.
18：Counter trigger signal input
Pulse input interface of counter built-in. Which frequency range is 0-500hz.
19：Exterior pulse input
The terminal receives exterior pulse as frequency given. Please refer to parameters
P5.04 and P5.05 for correlated settings.
6-28