EasyDrive CV3100 Series Instruction Manual page 120

CV3100 series and MINI series high performance general purpose inverter instruction manual
only effective when multi-step speed running function is available.
The priority of programmable multi-step speed is higher than external terminals
multi-step speed
P7.11 Wobbling frequency running mode
Setting range
LED single digit：Reserved
LED tens digit：Wobbling range control
0：Fixed
1：Variable
LED hundreds digit:
Selection of wobbling frequency start up mode after power off
0：Start up basing on memory before stop
1：Restart
LED thousands digit:
Selection of Wobbling frequency status storage after power off
0：Storing after power off
It recovery status automatically and run from the broken status after power-on.
1：Not storing
It restarts to run in wobbling frequency after startup.
Wobbling pre-setting frequency
P7.12
Setting range
Wobbling presetting frequency
P7.13
waiting time
Setting range
Presetting frequency is the operating frequency of which before the inverter running
into wobbling frequency control mode or which after the inverter running out of
wobbling frequency control mode. If P7.00=4, the inverter will run in wobbling
frequency presetting frequency after startup and ten run into wobbling frequency
running mode after the wobbling frequency presetting frequency waitingtime . If the
running command is controlled by terminal input, parameter P7.13 is invalid.
Note:
If the hundreds digit of parameter P7.11 is set to ―0‖, the wobbling presetting
frequency is invalid; If it is set to ―1‖, then each time wobbling frequency running
starts after stop, with frequency starting from wobbling presetting frequency point.
0000—111
0.00Hz—upper limit frequency
0.0—3600.0s
6-52
Factory setting
Factory setting
Factory setting
000
10.00Hz
0.0s