EasyDrive CV3100 Series Instruction Manual page 74

CV3100 series and MINI series high performance general purpose inverter instruction manual
2：Operated by PC through Communication interface
P0.05 Run direction setting
Setting range
By changing this function code, it can change the rotation direction of motor.
This function is equivalent to the change in the direction of rotation through
adjusting any two output lines of motor.
Note:
If this parameter has been set, when initializing the system parameter, the motor
rotation direction will be restored to the original state. It shall be carefully used for the
occasion that doesn't allow changing the motor rotation direction!
P0.06 Upper limit frequency
Setting range
P0.07 Lower limit frequency
Settitn range
Upper limit frequency is maximum output frequency of inverter, shown as fu, setting
range is from [P0.07] to 400.0Hz；Lower limit frequency is minimum output
frequency of inverter, shown as fi, setting range is form 0.00Hz to [P0.06]；Inverter
starts to run from its basic frequency. If the frequency gave is less than lower fi, the
inverter will run on fi until inverter stop or the frequency value gave more than fi.
P0.08 Basic runing frequency
Setting range
Basic running frequency, shown as fb, is the corresponding min. frequency at Max.
voltage output of inverter, which is usually rated frequency of motor and the base to
set frequency and acceleration or deceleration time.
Note: it can not be adjusted randomly.
Forward
0
1 Reverse
2 Reverse forbidden
[F0.07]—400.0Hz
0.00Hz—[F0.06]
1.00-Upper limit fequency (fu)
6-6
Factory setting
Factory setting
Factory setting
Factory setting
0
50.00Hz
0.00Hz
50.00Hz