Selecting The Module; Setting Parameters; Parameterization; Wago Webserver I/O Field - WAGO 765-1205/0100-0000 Manual

765-1205/0100-0000
ð The IP address has been set.
10.2 Configuration
10.2.1 Configuring EtherCAT
To configure the EtherCAT
files in XML format:
WAGO_series765.xml and WAGO_series765_diag.xml
The file WAGO_series765.xml contains a reference to the file WAGO_se-
ries765_diag.xml, which contains diagnostic texts. Perform the following steps in the con-
figuration software of the EtherCAT
• Import the XML files.
• Select the module from the device catalog.
• Set the parameters.

10.2.1.1 Selecting the Module

Select the module used from the device catalog.
Module: 0765-1205/0100-0000
Designation:8 DIO FLD EC 24 VDC 2.0 A

10.2.1.2 Setting Parameters

You can set the parameters for the module in the configuration software of the EtherCAT
master. The existing parameters contain the basic settings for the module, which you can
adapt to your application. Set the module and port parameters in the start-up parameters
in the configuration software of the EtherCAT
these parameters to the module when communication starts up.
You can find all the module parameters in

10.3 Parameterization

The following tools are described below:

• WAGO Webserver I/O Field

• WAGO I/O Field app
• OPC UA Server
10.3.1 WAGO Webserver I/O Field

10.3.1.1 Call WAGO Webserver I/O Field

This section describes how you can use the integrated software WAGO I/O Field Web-
server to get access to detailed information on the current operating state of the product
and make settings to affect the product's behavior.
ü Requirement: Opening the user interface of WAGO I/O Field Webserver requires that
product's IP address is configured and known.
Product manual | Version: 1.0.0
8DIO FLD EC DC 24V 2.0A
®
master, you need the ESI (EtherCAT
®
master used:
®
master. The EtherCAT
8 Module Parameters
Commissioning
®
Slave Information)
®
®
master sends
[} 39].
55