Connecting The Receiver To The Power Supply; Table 2.2: Fuse Type And Rating - TANDBERG RX8310 User Manual

RX8310/RX8315/RX8330 Distribution Receiver
2.5

Connecting the Receiver to the Power Supply

Connect the Receiver to the power supply as follows:
Power Supply
Ensure the power supply is isolated and switched off.
Receiver
Ensure the correct fuse type and rating has been fitted to both the equipment
and the power cable.
Supply Cord
Connect the lead to the Receiver input connector and then to the power
supply. Switch on the power supply.

Table 2.2: Fuse Type and Rating

Power Supply
100 - 240 V ac
10
WARNINGS
1.
Do not overload wall outlets and extension cords as this
can result in a risk of fire or electric shock
2. As no mains switch is fitted to this unit, ensure the local
power supply is switched OFF before connecting the supply
cord.
3. The Receiver is not fitted with an on/off switch. Ensure that
the socket-outlet is installed near the equipment so that it is
easily accessible. Failure to isolate the equipment properly
may cause a safety hazard.
Fuse Type and Rating
IEC/EN 60127-2 Sheet 5
Bussmann S505/Littelfuse 215
2 A 250 V T HBC