Overview; Standalone Configuration - Simplex 4010ES IDNAC Installation Manual

2 Overview

The 4010ES panel is an expandable fire alarm panel that can be used either as a standalone system or can be networked with the
following other panels to create a larger network:
• 4002
• 4010
• 4020
• 4100
• 4100U
• 4100ES
• 4010ES
• 4007ES
• 4190 TrueSite Workstation
• 4190 TrueSite Incident Commander
• 4190 Network System Integrator
It comes with basic system components already installed. This chapter provides an overview of the standalone and network 4010ES panel
concepts:
Standalone. Comprised of one 4010ES Fire Alarm Control Unit (FACU) and its assorted notification appliances, initiating devices, and
signaling line circuit devices.
Network. Multi-FACU systems connected by 4120 network cards or ES Net network cards. Each panel maintains the status and control
of its own circuit points while monitoring and controlling activity at other locations. Network nodes may perform similar tasks, or may be
dedicated to specific functions.
2.1

Standalone configuration

The standalone version of the 4010ES is used for smaller or single-building applications. A standalone system is ideally placed into a small
building that requires a limited number of notification appliances and initiating devices.
If a small building is being expanded, or if other buildings are being constructed in the same general area (as in a campus application), the
standalone 4010ES can be upgraded to a network system as described in the introduction to this chapter.
Note: You must order and install the 4010-9902 and the 4010-9922 network card into the standalone system to enable 4120 network
functionality. For ES Net network functionality, you must order and install the 4010-6310 network card.
page 4
4010ES IDNAC Fire Alarm System Installation Guide
579-1150 Rev M